SHT1X¶

Environment - SHT1X NORMAL

Introduction¶

Specifications:

Temperature
Humidity

Wiring¶

ESP               S8
GPIO (X)   <-->   TX
GPIO (X)   <-->   RX


Power
5.0V       <-->   VCC
GND        <-->   GND

Setup¶

This sensor does not communicate via some standard protocol. The clock line can be shared with other instances of this plugin in order to accommodate for more sensors on the same node.

Using long wires can cause a decay of the signal, due to the internal capacitance of the wire. To overcome this signal attenuation, the clock speed of the signal can be lowered.

For example, a delay of 10 usec can be enough to use 30m CAT6 UTP cable with these sensors. With a delay of 0, on a 80 MHz ESP8266, the clock signal is about 200 kHz. With a delay of 10, on the same node, the clock signal is about 40 kHz.

Rules examples¶

//Code below...

Indicators (recommended settings)¶

Indicator	Value Name	Interval	Decimals	Extra information
XXXXXX	N/A

Where to buy¶

Store	Link
AliExpress	Link 1 ($)

$ = affiliate links which will give us some money to keep this project running, thank you for using those.